GP Degreaser-25L, Make:Vecom

CAN, VECOM

In stock

SKU

1603100083

Quick Enquiry

Highly efficient heavy-duty general-purpose emulsifier cleaner. Based on petroleum solvents emulsifying surfactants.

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Applications
GP DEGREASER is a general oil and grease remover for deck and engine room. Most suitable for removal of oil and grease from machinery parts, tank tops, bulkheads, decks and floor plates and especially for tank cleaning. GP DEGREASER is also used for cleaning of cargo tanks, bunker tanks and for spot cleaning.
Directions for use
TANK CLEANING
Spraying method for tank cleaning:

Apply GP DEGREASER with a solution of 2 – 6% and allow product to soak / penetrate in surface deposits for 20 minutes.

Wash down the solution with high-pressure water.

Product can be used with cold water, but temperature up to 60°C always gives better results.

CIRCULATION METHOD FOR TANK CLEANING
A dilution of 2 – 6% of GP DEGREASER with water is the basic solution for circulation. Temperature up to 60°C will help cleaning results. Please contact us for specific instructions for tank cleaning.

GP DEGREASER is applied by soaking, spraying or combined with scrubbing.

SOAKING
Dip parts to be cleaned into bath of undiluted GP DEGREASER. Allow deposit to break up and loosen. Then rinse off with water (chemical cleaning module can be utilised for this application, allowing recirculation of the product). A higher temperature of the solution (up to 60°C) always increases the cleaning power of the product.

SPRAYING/CLEANING OF TANKS
Apply GP DEGREASER neat and allow product to penetrate into deposits for 15 – 20 minutes before rinsing off with water. For stubborn deposits some brushing may be necessary to accelerate removal. Before spraying a pre-wash with hot water of approx. 60°C is always helpful.
For tanks: Before cleaning with GP DEGREASER pre-wash with hot water of approx. 60°C, except for drying and semi-drying oils. Then spray with undiluted GP DEGREASER and let the product soak for at least 30 minutes. Rinse each tank for approx. 45 minutes with hot water at 60°C.

CLEANING OF COOLING SYSTEMS
Fill the cooling system with an emulsion of GP DEGREASER and water. Depending on the degree of contamination, 100 l of cleaning liquid should contain 5 – 10 l of GP DEGREASER. Allow this emulsion to circulate for 12 – 24 hours at a maximum temperature of 60°C. After this operation, drain the cleaning liquid and rinse the system thoroughly with water until the outlet water remains clear. Add cooling water treatment such as COOLTREAT NCLT to the system.